APEC SSR20 STANDING SEAM PANEL

Panel Features

• Panel Type

  Standing Seam

• Panel Seam

  Mechanical

• Panel Width

  18″ (Steel) / 16″ (Aluminum)

• Seam Height

  2.0″

• Panel Material

  22 GA – 24 GA Min. .040

• Panel Surface

  Smooth / Embossed Optional

• Panel Clip

  Required Per Engineering

• Minimum Slope

  2/12

• Substrate

  Open Framing* , Plywood, B – Deck w/ISO

Notes:

• With this panel engineering, you may opt to use heavier gauge coil and narrower width panels.
  Clip spacing will not change.
• For slopes lower than a 2/12 roof pitch, contract SMI Technical Department for further installation requirements.
• This panel uses a 24″ coil (Steel) / 22″ coil (Aluminum).
• This panel uses 5 – 13/16″ of material to form the panel.
• If you take the square footage of the roof and multiply that by 1.34, the total will be the amount of coil needed to manufacture the panels.
• Clip Relief, Bead Ribs, Striations, and Pencil Ribs do not affect the engineering or function.
• This panel is approved for Weathertight Warranties.